Avaya Definity SI, Руководство по обслуживанию, Страница: 2397 / 2968

TAPE (Tape Unit) [G3iV1.1-286]
Issue 4 May 2002 10-1611 555-233-123
TAPE (Tape Unit) [G3iV1.1-286]
NOTE:
Alarms on the TAPE, PROCR, and PR-MAINT MOs are indicated by the red
LED on the Processor circuit pack.
The Tape Unit consists of a Wangtek FAD3500 series tape drive mounted on the
TN774 Tape Drive circuit pack, which is controlled by the TN773 Processor circuit
pack. For tape controller functions, the processor uses memory on the TN770
Memory circuit pack.
The Tape Unit is used to:
■
Boot the system
■
Save or load translations and announcements
■
Save the Error Logs
■
Save core dumps
There are two versions of the test tape system technician command that can be
used to initiate maintenance tests on the Tape Unit: one for Standard systems and
one for High and Critical Reliability systems. In a Standard system, the command
line entry to test the TAPE (Tape) MO is test tape [short/long] [repeat n/clear].
In a High or Critical Reliability Option system, the command line entry to test the
TAPE (Tape) MO is test tape [short/long] [a/b] [repeat n/clear].
MO Name (in
Alarm Log)
Alarm
Level Initial Command to Run Full Name of MO
TAPE MAJOR test tape long
1
1 This alarm occurs only at power-up time or on a Reset System 3, 4, or 5 when the
system cannot load all translations from tape. Refer to the footnote associated with
Error Type 3329 in the “Hardware Error Log Entries and “Test to Clear Values”
section.
Tape Unit
TAPE MINOR test tape long Tape Unit
TAPE WARNING test tape long Tape Unit