Avaya Definity SI, Руководство по обслуживанию, Страница: 1632 / 2968

Maintenance Object Repair Procedures
555-233-123 10-846 Issue 4 May 2002
c. Type display data-module <ID> and press
Enter
to obtain the link
number.
d. Type status link <link_number> and press
Enter
to check the link
status and obtain the source IP address.
Self-download
In this procedure you will use an FTP client to copy the new firmware image file to
a circuit pack. Then you will copy the new image to the FLASH memory on the
pack. This procedure updates only a single circuit pack and applies to these
circuit packs:
■
Control LAN (C-LAN) (TN799DP)
■
Voice Announcements over LAN (VAL) (TN2501AP)
Set up file system on circuit pack
Before you can load files onto the source circuit pack, you must first set up a file
system on the circuit pack to accept the files.
1. Log onto the switch using superuser or services login and password.
2. Type enable filesystem board <UUCSS> login <ftplogin>
<ftppassword> [size actual_size], where
■
ftplogin is any temporary login for this FTP session, for example,
denver.
■
ftppassword is any temporary login for this FTP session, for
example, broncos.
and press
Enter
.
You will use this same ftplogin and ftppassword later in the ‘‘FTP the new
firmware image file’’ section.
NOTE:
The size actual_size qualifier only works with TN799C (C-LAN). It
allows you to specify a smaller filesystem size than the default 1MB
block (maximum) allocated.
If the source circuit pack does not have enough available memory,
delete old files (remove file board <UUCSS> <filename>) or wait
until there is less traffic on the board.
!
CAUTION:
The ftplogin and ftppassword will remain on the TN799DP (C-LAN)
and TN2501AP (VAL) circuit packs until they are reset or until you
issue the disable filesystem board <UUCSS> command.