Avaya Definity SI, Руководство по обслуживанию, Страница: 126 / 2968

Routine Maintenance Procedures
555-233-123 5-22 Issue 4 May 2002
Screen 5-2. Save Announcements Screen — SPEA
6. Verify that the command successfully completes. If not, an error message
appears. In such a case, refer to the “Translation Card Errors” section.
7. Remove the backup translation card and insert the original translation card.
8. Label the backup translation card with the date and time it was updated. A
special notation on the card clearly distinguishes it from other cards.
9. Store the backup translation card in a secure place.
Translation Card Errors
Translation card-related failures may occur for two reasons: the card is at fault, or
the Netcon circuit pack is at fault. The following is a list of the error messages and
recommended responses to each.
1.
Cannot access file storage area
—Implies that the wrong
translation card may be installed.
Response: Check to see which translation card is installed. If the correct
one is installed, test it.
2.
Cannot turn on 12 volt power supply
—Implies that something
may be wrong with the Netcon circuit pack, which contains the power
supply.
Response: Test the 12-volt power supply by entering the test card-mem
command from the terminal. Executing this command causes the system to
run Test 701 (12 Volt Power Supply Test). If the power supply test fails,
replace the Netcon circuit pack. Then repeat whichever command failed.
3.
Invalid directory on Card-Mem
— The translation card needs
refreshing. Run test card-mem and be sure all tests pass.
4.
Card-Mem is unusable
— Something is wrong with the translation
card. Replace the translation card.
5.
Could not write to Card-Mem
— Something is wrong with the
translation card. Test the translation card.
6.
Cannot access mass storage system now; try again later
— The storage system is in use. Try again later.
save announcements
SAVE ANNOUNCEMENTS
Processor Command Completion Status Error Code
SPE_A Success 0
Command successfully completely