Avaya CallPilot 703t, Установка оборудования, Страница: 41 / 52

5. Connect the power cord to the monitor, and plug the other end into a wall receptacle
or power bar.
6. Turn on the monitor.
To connect the modem to the server
1. Ensure that the modem's AC power cord is not plugged in.
2. Connect the large 25-pin male connector to the back of the modem. Tighten the
connector screws.
3. Connect the 9-pin female connector to COM1 port at the rear of the server. Tighten
the connector screws.
4. Connect one end of the telephone cable to the modem RJ-11 jack labeled LINE.
5. Connect the other end of the telephone cable to the RJ-11 jack in the wall.
6. Ensure that a single-point ground reference is available for all the power outlets
serving the CallPilot server and its peripherals. Before the CallPilot server
installation, a qualified electrician must implement the single-point ground reference
requirement between the power outlets of the CallPilot server and the power outlets
of the switch.
7. Connect the power cord to the modem, and plug the other end into a wall receptacle
or power bar.
8. Turn on the modem.
What is next?
Connect the server to the ELAN and CLAN hubs (if applicable).
IF the server will THEN
be connected to the ELAN Subnet continue with Connecting the server to the
ELAN subnet on page 42.
be connected only to a Avaya server subnet continue with Connecting the server to the
Avaya server subnet (optional) on page
43.
not be connected to either the ELAN subnet
or Avaya server subnet continue with installing the software feature
dongle. See
Installing the Avaya software
feature dongle on page 44.
To connect the modem to the server
Avaya CallPilot® 703t Server Hardware Installation December 2010 41