Avaya CallPilot 600r, Техническое обслуживание и диагностика, Страница: 77 / 106

3. Replace the server cover. For more details, see Removing and replacing the server
cover on page 74.
4. Take the ESD strap off.
5. Plug in the peripheral devices and Ethernet cables, connect the AC power cords,
and restart the server.
Replacing the power supply
The 600r has only one power supply. You must power down the server to replace the power
supply.
Important:
Do not remove the power supply while the system is running. Power down the system and
unplug the power supply before removing the power supply. After you power down the
server, allow the power supply to cool for several minutes.
To replace the power supply
1.
Voltage:
Risk of electric shock
High current inside the chassis can cause severe injury.
After you power down the server, allow the power supply to cool for several minutes.
2. Remove the server cover. For instructions, see Removing and replacing the server
cover on page 74.
3. Remove the PCI riser assembly. For instructions, see Replacing the MPB96 card on
page 82.
4. Lift up the rear of the power supply until it clears the two half-circle stops at the
rear of the power supply. See letters A and B in Figure 17: Removing the power
supply on page 78.
5. While holding the rear of the power supply above the stops, push back at the front of
the power supply to disconnect it from the power board. See (C) in Figure 17:
Removing the power supply on page 78.
Replacing the power supply
Avaya CallPilot® 600r Server Maintenance and Diagnostics December 2010 77