Avaya CallPilot 1006r, Установка оборудования, Страница: 42 / 46

Figure 10: 1006r server in a network
To connect the 1006r AC server to power
1.
Warning:
Risk of personal injury, risk of hardware failure
The power outlets used by the CallPilot server and its peripheral devices must
be connected to the same single-point ground reference as the one used by the
switch with MGate cards connected to the CallPilot server. If this requirement is
not met, power transients can cause personal injury, hardware failure, or both.
See the Installation and Configuration Task List (NN44200-306) for more
information about single-point grounding requirements.
Plug the server AC power cords into the server rear panel.
2. Plug the other ends into an approved wall receptacle or power bar.
To start the server
1. Press the server power switch to start the server.
2. Observe the Power-On Self Test (POST) and initialization messages on the monitor.
3. Let the mini-setup sequence run until you are prompted to log on to the operating
system.
Note:
The system can perform multiple reboots. This is normal.
4. Ensure that the operating system logon window appears on the monitor.
Connecting the server to power
42 Avaya CallPilot® 1006r Server Hardware Installation December 2010