Avaya Cajun P580, Руководство пользователя, Страница: 409 / 770

Document No. 650-100-700, Issue 1 12-93
Configuring IP Routing
CLI Command
To view configuration and LDAP statistics using the CLI, enter the
following command:
>
show ldap
Configuring a Static Route for the PPP Console
Web Agent
Procedure
To configure a PPP Console static route:
1. Configure your console serial port as a PPP Console. See the
“ Connecting a Modem ” section in Chapter 2 , “ Setting Up the Switch ”.
2. Select Static Routes from the Routing > IP > Configuration folders on
the Web Agent window. The IP Static Routes dialog box opens.
3. Select CREATE. The Add IP Static Routes dialog box opens
( Figure 12-6 ).
4. Enter the IP address that is to be associated with the PPP console port in
the Network Address field.
5. Enter the network mask IP address in the Mask field.
6. Enter the IP address of the gateway associated with this static route in the
Next-Hop Address field.
Producer
Signal The sequence number that, when modified, triggers the LDAP
client to download the latest policy from the LDAP server.
Typically, Avaya Policy Manager will set this value whenever
there is a new policy to download. If this value is a non-zero
value, the LDAP client will compare it to the producer signal
on the LDAP server. No comparison is made if the value is
zero.
Consumer
Signal Indicates the success of the LDAP client when downloading a
policy. If the consumer signal matches the producer signal,
downloading LDAP to a policy was successful. If the
consumer signal is -1, then either the LDAP client had a
problem processing the access lists or the consumer signal set
on the LDAP client did not match the signal configured on the
LDAP server. If the consumer signal is not -1 and does not
match the producer signal, then the LDAP client was unable to
connect to the LDAP server(s).
Table 12-35. LDAP Statistics Dialog Box Parameters continued
Parameter Definition
2 of 2