Avaya Cajun P580, Руководство пользователя, Страница: 176 / 770

6-18 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.0
Chapter 6
Optimizing Hunt Group Throughput
To optimize Hunt Group throughput follow these considerations.
■
Forwarding Engines in the Hunt group ports should be separate
from the ports involved in the modules traffic flows.
■
The greater the number of non-member Forwarding Engines in the
system, the greater the ability of the system to load-share.
■
Distribute the hunt group across more than one Fabric Port per slot
■
Distribute the hunt group across media modules
Hunt Group Configuration Considerations
Consider the following before creating hunt groups:
■
Hunt group end to end physical connections must be configured
with the hunt group ports connected to hunt group ports.
■
All ports of the hunt group must be of the same bandwidth and all
layer 2 or all layer 3 ports (but not a mix)
■
Can have a mix of 80-series and 50-series as long as they are the
same bandwidth and all layer 2 or all layer 3. (but not a mix)
■
A hunt group cannot be distributed between more than two
switches.
■
You must disable or disconnect the ports in a hunt group until both
ends of the link are configured.
■
All ports in the hunt group take on the configuration of the base port
■
Both sides of the hunt group have the same configuration
■
Any change to a port in the hunt group will be reflected on all ports.
■
When removing a port from a hunt group with the Web Agent, it
must be removed before its VLAN assignment is changed.
■
If 48-port mode is enabled on the switch, only the first thirteen hunt
groups are retained and all others are discarded. The ports
associated with the discarded hunts groups lose their hunt group
bindings, but retain their VLAN bindings and are still active as
VLAN bridges. Spanning tree may or may not, due to the topology
or spanning tree settings on those ports, forward traffic over
unwanted trunks.