Avaya C360 Manager, Руководство по установке и настройке

Страница: 66 / 248

Establishing Switch Access
66 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5
Assigning C360 IP Stack Address
Note:
Note:
All C360 switches are shipped with the same default IP address. You must
change the IP address of the master C360 switch in a stack in order to guarantee
that the stack has its own unique IP address in the network.
The network management station or a workstation running a Telnet client can establish
communications with the stack once this address had been assigned and the stack has been
inserted into the network. Use the CLI to assign the C360 stack an IP address and net mask.
To assign a C360 IP stack address:
1. Establish a serial connection by connecting a terminal to the master C360 switch of the
stack.
2. When prompted for a Login Name, enter the default name
root
3. When you are prompted for a password, enter the password
root
. You are now in
Supervisor Level.
4. At the prompt, type:
set interface inband <vlan> <ip_address> <netmask>
Replace
<vlan>
,
<ip_address>
and
<netmask>
with the VLAN,
IP address, and net mask of the stack.
5. Press Enter to save the IP address and net mask.
6. At the prompt, type
reset
. Type y and press Enter to reset the stack. After the Reset, log in
again as described above.
- At the prompt, type
set ip route <dest> <gateway>
and replace
<dest>
and
<gateway>
with the destination and gateway IP addresses.