Avaya C360 Manager, Руководство по установке и настройке

Страница: 56 / 248

Powering Up the Avaya C360
56 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5
2. Connect the power cable to the terminals on the C360 and then external DC power supply.
!
WARNING:
WARNING:
Make sure that you connect the cables between the C360 and the external power
supply correctly:
●
Positive (“+") to positive (“+")
●
Negative (“-") to negative (“-")
!
ADVERTENCIA:
ADVERTENCIA:
Asegúrese que las polaridades de los cables entre el C360 y la fuente de
alimentación externa estén conectados correctamente:
●
Positivo ("+") a Positivo ("+")
●
Negativo ("-") a Negativo ("-")
3. Replace the plastic cover by aligning the holes with the screw receptacles and replacing the
two Phillips screws.
Supplemental Earthing of the C360 (Optional)
When connecting a BUPS to the C360, you must also connect a ground wire to the ground stud
provided on the rear of the unit. This ground conductor must be green/yellow, a minimum of 16
AWG and be terminated with a lug that is suitable for the M4 stud provided. The other end of the
ground conductor is to be terminated to a suitable building ground point such as a cold water
pipe.