Avaya C360 Manager, Руководство по установке и настройке

Страница: 138 / 248

Avaya C360 Layer 2 Features
138 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5
LAG (Link Aggregate Group)
LAG Overview
A LAG uses multiple ports to create a high bandwidth connection with another device. For
example: Assigning four 100BASE-T ports to a LAG on an C360 allows the switch to
communicate at an effective rate of 400 Mbps with another switch. LAGs provide a
cost-effective method for creating a high bandwidth connection. LAGs also provide built-in
redundancy for the ports that belong to a LAG. If a port in a LAG fails, its traffic is directed to
another port within the LAG.
The behavior of the LAG is derived from the base port (the first port that becomes a LAG
member). The attributes of the base port, such as port speed, VLAN number, etc., are applied to
all the other member ports in the LAG.
When created, each LAG is automatically assigned a logical port number (usually designated
10x). This logical port number can then be used as any regular panel port for all configuration
required for the LAG (Spanning Tree, Redundancy, etc.).
Note:
Note:
You need to erase all ports in the LAG in order to remove it.
LAG CLI Commands
The following table contains a list of the CLI commands for the LAG feature. The rules of syntax
and output examples are all set out in detail in the
Reference Guide for the Avaya C360
Converged Stackable Switch, 10-300506.
In order to... Use the following command...
Enable or disable a Link
Aggregation Group (LAG)
logical port on the switch set port channel
Display Link Aggregation Group
(LAG) information for a specific
switch or port show port channel