Avaya BSGX4e, Руководство по установке

Страница: 30 / 56

BSGX4e Business Gateway Installation Guide 30
Release 01.01 NN47928-303
„
The IP address of the LAN (eth1) interface restores to its default, 192.168.1.1.
„
The IP address of the WAN (eth0) interface restores to its default, 0.0.0.0. DHCP
service activates by default for the eth0 interface so an IP address can be
assigned by DHCP.
To reconnect from the LAN, enter the IP address of the eth1 interface (192.168.1.1)
on the browser entry line. If the browser cannot connect to the default address, the
default address must be reconfigured from the eth0 interface or from the console.
Erase Command
You can restore the default configuration from a terminal session using the erase
command in the CLI. The procedure for starting a terminal session is described in
"Log on to the BSGX4e" on page 21 .
Note: When you restore the unit to factory default settings, any remote
connections to the unit are lost. The eth1 interface is assigned the default
IP address 192.168.1.1; the eth0 interface does not have a default IP
address, although DHCP service is enabled by default, so an IP address can
be assigned by DHCP.
1 To erase the current configuration and return the unit to its initial factory
configuration, enter:
ICAD> erase
The unit responds:
The system will reboot automatically after erasing the
configuration.
Are you sure you wish to erase the configuration [y/N]:
2 To erase and restart the system, enter:
Are you sure you wish to erase the configuration [y/N]: y
The system erases the current configuration, reloads the factory default
settings, and restarts. The reload begins with the following message:
Configuration erased, reloading system.....
Note: If the sessions is a remote session, it attempts to reconnect to the default
IP address.
3. A new session begins with the following prompt:
User: