Avaya AA1419043-E6, Руководство по установке, Страница: 35 / 72

Procedure
1. Disconnect the network fiber optic cable from the SFP connector.
2. Depending on your SFP model, to release the SFP, pull the latch handle and use it
to extract the module.
3. Slide the SFP out of the module SFP slot.
If the SFP does not slide easily from the module slot, use a gentle side-to-side
rocking motion while firmly pulling the SFP from the slot.
4. Affix dust covers over the fiber optic bore and connector.
5. Store the SFP in a safe place until needed.
Important:
If you discard the SFP, dispose of it according to all national laws and
regulations.
SFP specifications
This section provides technical specifications for the supported small form factor pluggable
(SFP) models. Use this information to aid in proper network design.
The specifications in this section meet or exceed those specified in the applicable IEEE
standards, where they exist.
In these specifications, unless otherwise noted, receiver sensitivity is the minimum average
input optical power for which Avaya guarantees the receiver meets the bit error rate (BER) of
10
-12
.
Important:
For instances where you install a significant number of long-range SFPs and SFP+s, you
must be sure to have sufficient power available to power these optical devices.
SFP labels
The Avaya label on a typical SFP contains an Avaya serial number, a bar code, a manufacturer
code, an interface type, and a part number.
SFP specifications
Installation — SFP Hardware Components December 2012 35