Avaya 4524GT, Руководство по настройке

Страница: 170 / 362

default lldp command
The
default lldp
command sets the LLDP transmission parameters to their default values.
The syntax for the
default lldp
command is
default lldp [tx-interval ] [tx-hold-multiplier ] [reinit-delay] [tx-
delay] [notification-interval] [med-fast-start]
If no parameters are specified, the
default lldp
sets all parameters to their default
parameters.
Run the
default lldp
command in Global Configuration command mode.
The following table describes the variables for the
default lldp
command.
Table 81: default lldp command variables
Variables Description
tx-interval Set the retransmit interval to the default value (30).
tx-hold-multiplier
Set the transmission multiplier to the default value
(4).
reinit-delay Set the reinitialize delay to the default value (2).
tx-delay Set the transmission delay to the default value (2).
notification-interval Set the notification interval to the default value (5).
med-fast-start
Set the MED fast start repeat count to the default
value.
default lldp port command
The
default lldp port
command sets the port parameters to their default values. The
syntax for the
default lldp port
command is
default lldp port <portlist> [config notification] [status]
Run the
default lldp port
command in Interface Configuration command mode.
The following table describes the variables for the
default lldp port
command.
Table 82: default lldp port command variables
Variables Description
port <portlist> The ports affected by the command.
System configuration using ACLI
170 Configuration — System April 2011