Avaya 4524GT, Руководство по настройке

Страница: 147 / 362

Run the
no flowcontrol
command in Interface Configuration mode.
The following table describes the parameters for this command.
Table 62: No flowcontrol parameters
Parameters and
variables
Description
port <portlist> Specify the port numbers for which to disable flow control.
Important:
If you omit this parameter, the system uses the ports you
specified in the interface command, but only those ports
that have speed set to 1000/full.
default flowcontrol command
Use the
default flowcontrol
command only on Gigabit Ethernet ports to set the flow
control to automatic, which automatically detects the flow control.
The syntax for the
default flowcontrol
command is
default flowcontrol [port <portlist>]
Run the
default flowcontrol
command in Interface Configuration mode.
The following table describes the parameters for the command.
Table 63: Default flowcontrol parameters
Parameters and
variables
Description
port <portlist> Specify the port numbers to default to automatic flow control.
Important:
If you omit this parameter, the system uses the port number
you specified in the interface command.
Enabling rate-limiting
The percentage of multicast traffic, or broadcast traffic, or both, can be limited using ACLI. For
details, see the following sections:
• show rate-limit command on page 148
• rate-limit command on page 148
General switch administration using ACLI
Configuration — System April 2011 147