Avaya 4524GT, Руководство по настройке

Страница: 133 / 362

Parameters Description
• configured-address—use configured server IP address
• dhcp-always—always use the DHCP server
• dhcp-last-address—use the DHCP server last used
• dhcp-when-needed—use the DHCP server when needed
stack | switch | unit Specifies the IP address and netmask of the stack or the switch,
or another unit in at a stack.
Important:
When you change the IP address or subnet mask, connectivity to Telnet and the Web can
be lost.
default ip address command
The
default ip address
command sets the IP address, subnet mask, and boot mode for
the switch or a stack to default.
The syntax for the
default ip address [source]
command is
default ip address
Run the
default ip address
command in Global Configuration command mode.
The following table describes the parameters for the
default ip address
command.
Table 49: default ip address parameters
Variable Value
source Configures the BootP and DHCP boot mode to default for the
next system reboot.
Important:
When the IP gateway changes, connectivity to Telnet and the Internet can be lost.
no ip address command
The
no ip address
command clears the IP address and subnet mask for a switch or a stack.
This command sets the IP address and subnet mask for a switch or a stack to all zeros (0).
The syntax for the
no ip address
command is
no ip address {stack | switch | unit}
General switch administration using ACLI
Configuration — System April 2011 133