5
EN
F U S E
H O L D E R
not more
40
cm
BATTERY
S T A N D A R D C O N N E C T I O N D I A G R A M
Connect the speaker cables from the plus and minus terminals of the speakers to the respective outputs on the amplifier
terminal marked with SPEAKER, as shown at the diagram.
To connect the power wire supply is necessary to use special cables.
The
fuse is placed in the holder and fixed in the cable cut. One end of the cable is connected to the positive terminal of the battery, the
second one – to the amplifier terminals marked with + 12V. Be sure to use a fuse with the parameters suffcient for use in the
system.
The length and diameter of the grounding cable must conform to the length and diameter of the cable + 12V. Connect
one end to the negative terminal of the battery and the other end of the grounding cable to the terminals marked with
GND.
For amplifiers with RMS power less than 1000 watts, the GND terminal can be connected to the car body.
2-8
Ohm
-
+
S T A N D A R D W I R I N G D I A G R A M O F 4 - C H A N N E L A M P L I F I E R T O F O U R S P E A K E R S
2-8
Ohm
-
+
2-8
Ohm
-
+
2-8
Ohm
-
+
2-8
Ohm
-
+
Minimum permissible load in a bridge connection - 4 Ohms
min
. 4
Ohm
S T A N D A R D W I R I N G D I A G R A M O F 4 - C H A N N E L A M P L I F I E R T O T W O S P E A K E R S W I T H
O N E S U B W O O F E R
2-8
Ohm
-
+
2-8
Ohm
-
+
