CHAPTER 5
Instructions, use and maintenance manual
Page 46
D r a g o P 1 P L U S
5.7. INSTALLING THE BURNER
Once the hole has been created in the cooking base, you can proceed to install the burner in the oven; please
refer to the procedure described below for burner installation.
5.7.1. FIXING THE FLANGE WITH SLEEVE
Each flange with sleeve is customised to fit the Customer’s oven, on the basis of the indications provided at the
time of the order.
CAUTION!
The flange with properly installed sleeve must always stick out by about 30 mm from the cooking
base surface, in order to protect the burner against potential collisions and falling material.
Each flange with sleeve is equipped with 4 fixing holes.
Under normal conditions it is possible to fix the flange to the lower part of the base using the 4 holes arranged at
the corners of the flange.
STEP
ACTION
1
Insert the sleeve in the hole previously created in the base, making sure that the upper end sticks out
by about 30 mm inside the cooking chamber.
2
Rotate the flange so that the studs are lined up radially with respect to the centre of the cooking
chamber.
3
Secure the flange to the bottom part of the base by using the special holes.
•
use self-threading holes for plate bottoms;
•
use expansion plugs for masonry bottoms;
•
use anchors for bottoms made of hollow flat tile.
PIZZA LOADING
DOOR
