Avanti WDE98PS, Инструкция по эксплуатации, Страница: 8 / 15

8
Electronic Controls
NOTE: At any time during the program set up, if no activity is chosen the screen will reset after 10
seconds have passed.
POWER Function
:
Press Power button onc e to power unit ON. The unit is in stand-by mode and the time will be displayed
on the upper left corner of the display window. To switch OFF the power, just push the Power button
again.
Clock Display
Press the SET button to adjust the time. Once pressed, the time will flash. Using the HOT (+) or COLD
(-) buttons you can adjust the “hour” display AM / PM. Press the SET button again to adjust the
minutes. Using the HOT (+) or COLD (-) buttons you can adjust the “minutes” display.
Wait for the display to stop blinking (approximately 10 seconds).
TEMPERATURE DISPLAY
HOT Function.
Press the HOT button once to turn on the hot function.
Press the SET button (3 times) the amber numbers appear on the left side of the display panel. Using
the HOT (+) or COLD (-) buttons you can adjust the temperature to the desired setting. Wait for the
display to stop blinking (approximately 10 seconds).
COLD Function
Press the COLD button once to turn on the cold function.
Press the SET button (4 times) the blue numbers appear on the right side of the display panel. Using the
HOT (+) or COLD (-) buttons you can adjust the temperature to the desired setting. Wait for the display
to stop blinking (approximately 10 seconds).
Cº/Fº Function:
Press Cº/Fº button to convert temperature display from Celsius to Fahrenheit or visa versa.
NOTE : Once the selected temperature is reached, the readout will display it. Since it may take a while to
reach the selected temperature, you will be able to see in numerical sequence (plus or minus) other
temperature readings.
COLD Water temperature range is from 41ºF-59F (5ºC-15ºC). The factory-preset setting is 6ºC/45ºF.
HOT Water temperature range is from 122ºF-198ºF (50ºC-92ºC). The factory-preset setting is
91ºC/196ºF.