ID
:
025489
Revision:
1-00
4
© Avantes BV
2
AvaLight-XE-HP
2.1 Quick start
SMA-plug
Connect the SMA connector of the fiber to the SMA plug of the light source.
I/O connector
For pulse mode to be controlled by software it is needed to connect an AvaSpec spectrometer to the
AvaLight-XE-HP with the Y interface cable. The other end of the Y cable goes to the power supply.
Now it is possible to control the output operation mode by software (AvaSoft).
The signals on the I/O connector are described below.
Pin configuration
CON 1: DB9 (AvaLight-
XE-HP)
CON 2: DC jack
(power supply)
CON 3: DB26
(spectrometer)
Description
1
Middle pin
-
+12V (middle core)
2
Middle pin
-
+12V
3
-
-
-
4
-
1
GND
5
-
5
Strobe
6
Shield
-
GND (outer core)
7
Shield
-
GND
8
-
-
-
9
-
-
-
SMA plug
I/O connector
