8
Installing Your Door Handle and Shelves
INSTALLING THE DOOR HANDLE:
1.
Open the door and carefully pull the door gasket around the area where the handle is to be installed.
2.
Insert each Phillips head screw through the gasket side of the door until the screw pass through the door.
3.
Align the handle with the screws and tighten using a Phillips head screwdriver until the handle is flush against the
door frame.
CAUTION:
Do not over-tighten the screws as this may cause damage to the handle or to the stainless
steel door.
4.
Carefully press the door gasket into its original position.
INSTALLING THE SHELVES:
1.
Open the door completely.
2.
Line up the shelf notches with the rail posts on both the right and left sides.
3.
Push the shelf down and then push it all the way inwards until the shelf fully rests inside of the unit and you are able
to close the door.
4.
The shelf should glide smoothly back and forth. If it does not, you may need to remove it and start over.
TIP
: To prevent damaging the door gasket, make sure to open the door fully before pulling the shelves out of their track.
REMOVING THE SHELVES
:
1.
Open the door completely.
2.
Remove all of the contents loaded on the shelf, if applicable.
3.
Line up the shelf notches with the rail posts as indicated below. This will require you to hold on to both rails as you
move the shelf to line up the posts with the notches on both sides of the shelf.
4.
Evenly lift the shelf up and then pull the shelf out.
NOTE
: This model is manufactured with all rails pre-installed for maximum storage capacity. Our factory default is to
include a pre-installed display shelf designed to accommodate most 750 ml wine bottles. Additionally, we include three
extra storage shelves for those who opt for more storage capacity. If you choose to utilize the included display shelf,
most users will have no functional issues gliding the display shelf back and forth with the factory installed rail above the
display shelf still installed. However, some larger Burgundy bottles may contact the overhead post. If this happens, we
recommend you remove the interfering rail and re-install just the Phillips head screws in the cabinet so there are no holes
left agape.
TIP:
Safely store any removed hardware for possible future use.
