9
Operation
INSTALLATION CHECK LIST BEFORE OPERATION:
1.
Have all packing materials and tape been removed from the interior and exterior of the wine refrigerator?
2.
Have the installation instructions been followed, including connecting the machine to electricity?
3.
Has proper grounding been installed for the wine refrigerator?
4.
Has the machine been leveled?
5.
Is the wine refrigerator in a site where the ambient temperature is between 50º F and 90º F all year round?
6.
Is there a clearance of at least 2 to 3” at the rear for proper air circulation?
USING YOUR CONTROL PANEL:
This wine cooler has a temperature range from 40°F to 65°F.
The upper zone has a temperature range of 40°F to 54°F.
The lower zone has a temperature range of 54°F to 65°F.
POWER BUTTON: Press and hold down for three seconds to power your unit on. Once pressed
the “Run” indicator light will illuminate to indicate the unit is on and running. Press and hold for
three seconds again and the unit will power off and the “Run” Indicator light will turn off.
UPPER ZONE TEMPERATURE: To change the temperature of your upper zone, press this button
to lower the temperature by one (1) degree increments. Once the temperature setting is set at
40° pressing again will bring it back to 54°.
LOWER ZONE TEMPERATURE: To change the temperature of your lower zone, press this button
to lower the temperature by one (1) degree increments. Once the temperature setting is set at
54° pressing again will bring it back to 65°.
INTERIOR LIGHT: Press this button to cycle through the different internal light settings. There
are four light settings - Constant Blue, Constant White, Automatic Blue, and Automatic White.
Press this button to cycle through the different light settings. The lights will fade as the unit
transitions between light settings. Press and hold this button for three seconds to turn the light
on/off. Open and close the door to check the color and the current setting. Please refer to the
“Internal Light” section on the next page for further detail.
NOTE
: Pressing and holding the Upper Zone and Lower Zone Temperature buttons at the same time will switch the
temperature display from °F to °C
TIP
: If you powered off the unit, please wait at least five (5) minutes before powering it back on.
WARNING
: Allow at least 24 hours for your wine cooler to run before storing your wines and to allow the temperature to
acclimate. Whether your wine cooler can reach the actual set temperature depends on the ambient environmental
conditions.
