6
INSTALLING THE SHELVES:
1.
Open the door completely.
2.
Push the shelf tracks affixed to the walls of the inner cabinet to the rear of the unit so that the tracks are
fully seated inside the cooler compartment.
3.
Line up the rails affixed to the shelf with the corresponding wine cooler tracks attached to the inner
cabinet walls.
4.
Push the front of the shelf inwards evenly until the shelf rests fully inside of the unit and you are able to
close the door.
5.
The shelf should glide smoothly back and forth. If it does not, you may need to remove it and start over.
REMOVING THE SHELVES:
1.
Open the door completely.
2.
Remove all of the contents loaded on the shelf, if applicable.
3.
Pull the shelf towards yourself until it is fully extended outward.
4.
The shelf has plastic posts on both sides as indicated in the diagram below. While facing the unit, press
the plastic post on the right side down while pulling up on the left plastic post. You may choose to do this
by hand or by using a flathead screwdriver.
5.
Evenly pull out the shelf from the track until it is completely removed from the inner compartment.
Operation
INSTALLATION CHECK‐LIST BEFORE OPERATION:
1.
Have all packing materials and tape been removed from the interior and exterior of the wine
refrigerator?
2.
Have the installation instructions been followed, including connecting the machine to electricity?
3.
Has proper grounding been installed for the wine refrigerator?
4.
Has the machine been leveled?
5.
Is the wine refrigerator in a site where the ambient temperature is between 50° F and 90° F all year
round?
6.
Is there a clearance of at least 2” to 3” at the rear for proper air circulation?
Tip: To prevent damaging the door gasket, make sure to open the door fully before pulling the shelves out
of their tracks.
