Instructions and user manual ChloriProtect
NOT004ENV05
2
The electrical installation to which the device is connected must comply with the standards and good
practice rule in force in the country under consideration.
Use of electrical equipment always implies observance of some basic rules. In particular:
- Do not touch with wet or damp hands or feet.
- Do not operate the device with bare feet (typical place: swimming pool)
- Do not leave the equipment exposed to the atmospheric agents
- Do not allow the device to be used by children or unskilled individuals without supervision
• The device must be supplied through a circuit with a residual current differential device (RCD) rated
differential operating current not exceeding 30 mA
• The appliance must be placed in a place that can not be flooded.
• The appliance must be connected electrically via a means of disconnection to the supply network, the
opening of the contacts of all the poles ensuring a complete break under the conditions of overvoltage
category III.
• The power supply is protected by a thermal fuse T315 mA 250V.
• The auxiliary output is protected by a fuse F2: T 3.15 A 250V.
In case of breakdown or improper functioning of the device, switch off, but do not touch. Contact our
technical assistance for any necessary repairs and insist on the use of original spares. Failure to respect this
condition could render the device unsafe to use.
• For Australia and New Zeland Only, For stationary appliances permanently connected to the fixed wiring,
compliance with this requirement is considered to be met if the instruction considering disconnection
incorporated in the fixed wiring is in accordance with AS/NZS 3000.
• In case of damage of power supply cord please ask the repair to our technical assistance or qualified and
authorized personnel, to avoid any hazard.
When you decide to make no further of an installed device, make sure to disconnect it from the power
supply. Before carrying out any service on the item, check to disconnect the plug from the mains.
1.5 - TOXIC AND/OR DANGEROUS LIQUID DOSAGE
To avoid risk from contact with hazardous liquids or toxic fumes, always adhere to the notes in this
instruction manual:
• Follow the instructions of the dosing liquid manufacturer
• Use only the correct materials fir the tubing, valves and seals to suit the liquid to be dosed (if you use liquid
regulation): where possible shield the tubing with PVC conduit.
1.6 - ASSEMBLING AND DISMANTLING THE DEVICE
1.6.1 -ASSEMBLY
See paragraph
3.0 “INSTALLATION AND RECOMMENDATION”
1.6.2 - DISMANTLEMENT
Proceed as follows when you dismantle the device or before performing any operation on it:
1) Disconnect the plug from the mains.
2) See paragraph
1.2 “SHIPPING AND TRANSPORTING”
