AV TOOL AVT-6041, Инструкция по эксплуатации, Страница: 7 / 10

7
4.1 Connecting the Inputs to the AVT-6041
You can connect any HDMI compliant device’s output to any of the AVT-6041’s
inputs. Make certain that the HDMI cable is securely plugged into the source
device as well as the AVT-6041. Always use a high quality cable, as short a
length as possible, for best results.
4.2 Connecting the AVT-6041 to a Display
Using a high quality HDMI cable, connect the output of the AVT-6041 to an HDMI
compliant display device. Use the shortest cable run possible.
4.3 Connecting Power to the AVT-6041
The AVT-6041 is shipped with a Power Adapter to convert 100~240VAC@50-
60Hz to 5VDC. Connect the DC Output Cable from the Power Adapter to the
back of the unit and then plug the Power Adapter into an AC Receptacle. You
will be able to turn the AVT-6041 via either the front panel power switch or the
power switch on the remote control.
5.0 OPERATING THE AVT-6041
The AVT-6041 4x1 HDMI Switcher can be operated via the front panel controls. If
the cable run length is excessive and the quality of the display is less than
optimum, you can press the Enhance switch on the front panel which will turn on
a low noise amplifier within the switcher and light an LED indicating that the
amplifier is in use. Provided there is enough signal for the amplifier to recover the
HDMI bitstream, you will be able to use inputs and a display located farther apart
than is normally possible. Another front panel control is the input select switch.
This switch is pressed to select the desired input. Each time the switch is
pressed, the next input in sequence (from left to right) is selected. LED displays
indicate which input is active. Finally, there is an On/Off Power Switch and an
indicator LED that shows when the unit is turned on.
5.1 Operation of the AVT-6041 via Remote Control
Operation of the AVT-6041 is possible via an included
Infrared Remote Control. Selection of Enhance mode
is not possible from the IR Remote however the unit
can be turned on and off and the inputs can be
selected simply by pressing the appropriate button on
the remote.
Note: When you unpack the AVT-6041,
you may have to remove an insulator from the battery
compartment of the remote in order for the remote to
receive power. The battery compartment slides out
from the bottom of the unit.