Autoplugin RCP-V2, Руководство по установке

Страница: 8 / 8

8
4 Time limits
exceeded Time limit for
autonomous operation
of the heater is
achieved (with applied
setting 1.1) Run the engine or cancel 1.1
setting
5 Unsuccessful
start The heater was
switched off
spontaneously at
startup Make diagnostics of the heater
if the error appears again
6 Operation
cycle too
short The heater was
switched off
spontaneously with
operating time of less
than 20 minutes Make diagnostics of the heater
if the error appears again
8 CAN-bus
error The lines X2.9 и X2.10
connected incorrectly Check the lines connection
9 Settings error Settings have been
incorrectly stored in
RCP’s memory
Reset the settings (8.1.1),
readjust RCP
11 Heater no
connection The heater is
unplugged from CAN-
bus or is out of order Make diagnostics of the heater
12 Unknown
CAN-bus CAN-bus type has not
been determined Check for compatibility of RCP
module with the car. Try to set
the CAN-bus code manually*
* Information available on request
© Autoplugin ES www.autoplugin.ru