GENERAL WARNINGS
1. Save the instructions. These safety and operating instructions must be kept in a safe place for
future reference.
2. All warnings on this product and in the instructions must be observed closely.
3. All operating instructions must be followed.
4. If the these instructions are not followed, damage to the product itself may result.
5. Install your controller at least 8
'
away from any devices that produce electronic interference,
such as electronic ballasts or ozone generators.
6. This controller can only accept standard 120V Nema 1-15P and Nema 5-15P plugs. Do not insert
any other plug type into it.
7. Do not use this controller near water or any water source. It should not be exposed to any
dripping or splashing water, as it is not waterproof nor shockproof.
8. Any serviceable parts inside or outside the unit should only be replaced by Hydrofarm.
9. If the power cord is damaged, please stop using the product immediately. Unplug the unit and
contact the retailer you purchased it from.
10. The unit is equipped with a circuit breaker that will automatically shut it down at once. All
outlets of the product all have the safety ground.
11. Do not install the unit near any heat source.
12. Do not block any ventilation openings in the controller housing.
13. This product is a Safety Class I Controller and is equipped with a Nema 5-15P plug. The main
plug should only be inserted into a properly grounded power outlet. Any alteration of the
power cord is likely to make the product dangerous and will void the warranty.
SULFUR VAPORIZER WARNING
If a sulfur vaporizer is used, first remove the remote sensor unit from the affected area or turn
the controller off and cover the remote sensor probe with a protective plastic bag. Remove
the bag before turning the power back on. Failure to protect the sensor while using a sulfur
vaporizer will result in damage to its infrared component and will void the warranty.
8' (2.5 m)
minimum
11
