Page 25
7.6.9
Set Time of Day (Optional Feature w/ 863A Expansion Board)
Change the time of day display to correct for time zone or Daylight Saving.
1) Press MENU, press
or
until “
Owner options
”, “
Maintenance Menu
” or
“
Installer Menu
” is displayed, then press SELECT.
2) Press
or
until “
Set time of day
” is displayed, then press SELECT (Eastern
Standard Time is the factory setting).
3) Press
or
until the desired hour is displayed, then press SELECT.
4) Press
or
until the desired minutes are displayed, then press SELECT.
5) Press
or
until “
End menu mode
” is displayed, then press SELECT.
7.6.10
Set Purifier Off (Optional Feature w/ 863A Expansion Board)
The Digital Nano/Nano+ system can be programmed to delay chlorine production if salt will not
been added to the pool water for a specified amount of time, from 1-28 days. The system will
automatically start up in the Purifier mode after the user defined time has expired. This feature
can be used when starting up a newly constructed or resurfaced pool when salt is not going to
be added for a few days. The unit will display normal operating messages, including salt levels,
but will not show error messages related to chlorine production or salt levels.
1) Press MENU, press
or
until “
Installer menu
” is displayed, then press and hold
SELECT for approximately 13 seconds to enter the Installer menu.
2) Press
or
until “
Purifier Off
” is displayed, then press SELECT.
3) Press
or
until the desired amount of days “
## Day(s)
” is displayed, and then
press SELECT.
4)
The display will flash “
Purifier Off; ## Day(s)
” three times and then display the
next menu option.
5) Press
or
unti
l “
End menu mode
” is displayed, then press SELECT.
The system will now begin to count down and will not generate chlorine until the amount of
time chosen has expired.
To turn this feature off before the designated time has elapsed:
1) Press MENU, press
or
until “
Installer menu
” is displayed, then press and hold
SELECT for approximately 13 seconds to enter the Installer menu.
2) Press
or
until “
Purifier Off
” is displayed, then press SELECT.
3) The days remaining will be displayed; Press
until “
0 Day(s)
” appears, then press
SELECT.
4) Press
or
until “
End menu mode
” is displayed, then press SELECT.
7.6.11
Set Reverse Time
Program the Cell
’s self-cleaning cycle.
CAUTION
: Failure to heed the following may result in equipment damage.
Reduced polarity reversing cycle times will
reduce
cell life and should only
be used due to uncontrollable scale formation on the cell.
Always
test and
adjust water balance, before attempting scale control via shortening reverse
period. See “Using the Saturation Index” in section 10.2 on page 51.
1) Press MENU, press
or
until “
Maintenance menu
” is displayed; then press
SELECT.
2) Press
or
until “
Set reverse time
” is displayed; then press SELECT (4 hours is
the factory setting).
