4
PANIC FUNCTION:
The transmitter can be used as a remote panic switch to manually trigger the alarm in case of
emergency.
1. Press and hold the
button on the transmitter for 3 seconds. The alarm will immediately
sound.
2.
During panic mode, the normal function of this transmitter button will be suspended. The
and
buttons can be used to lock and unlock the doors (if the option is installed),
however once the
button is pressed, the vehicle’s starter disable device, (where
installed) will be enable allowing the vehicle to start.
3.
To stop the alarm, press and hold the
or
or
button on the transmitter for 3
seconds. Also if the
button is pressed and released, the panic mode will be turned
off immediately.
4.
If the button is not pressed, the alarm will automatically stop after 30 seconds.
TRIGGER THE SYSTEM
When armed, your vehicle is protected as follows:
1. Light impacts will trigger the warn-away signal. A long chirp from siren/horn.
2. Heavy impacts / Doors open / Hood open / Trunk open / Turning on the ignition switch- All
will trigger the programmed sequence.
The starter disable relay (if installed) prevents the vehicle’s starter from cranking. The siren and
parking lights will turn on to alert of an intrusion for 30 seconds. Then the siren will stop and
automatically reset and re-arm. If any the sensors or detectors are still active, the alarm system
will sound a maximum of three-60 sec ond cycles.
IGNITION CONTROL DOOR LOCKS.
(See Feature
II – 3
Programming.).
If the vehicle’s door locks have been interfaced to the security system, the system will
automatically lock the vehicle's doors when the ignition is turned “ON” and /or unlock the
vehicle’s doors when the ignition is turned “OFF”.
TRUNK RELEASE.
(See Feature
III – 1
Programming.).
Press and hold
button on transmitter for two seconds to remote control the trunk release
or other electric devices.
CAR LOCATOR
Under Armed mode, press the
button on the transmitter to active car locator function.
The siren will chirp 6 times. The parking light will flash 12 times, for you to easily locate
your car.
DOME LIGHT CONVENIENCE DEL AY & SUPERVISION
The alarm with a unique feature which will turn on your vehicle dome light as following:
1.
Upon disarming, the interior lights will remain on for 30 seconds.
2.
If the vehicle is intruded, the interior light will flash for the same duration as the siren.
Note: Turn ON the ignition switch or arm the alarm will turn off the dome light.
CHANNEL 3 TIMER CONTROL OUTPUT
(See Alarm Feature
III – 2
Programming.)
Press the
+
button on the transmitter to active Channel 3 function. (Factory Default )
Press the
button on the transmitter to active Channel 3 function.
(If you Program
button = Channel 3 Function)
Channel 3 is user-programmable timer output. You may program the built-in timer to send a
ground signal for any time interval between 1 second and 2 minutes. For instance, this timer
output may be used to turn on the headlight, power window or sunroof.
Note: Factory default setting at momentary output.
