Autonics AiC Series, Руководство пользователя

Страница: 29 / 88

4 Installation of Motor
© Copyright Reserved Autonics Co., Ltd. 29
4.3 Connection with Load
When connecting the load, be sure of alignment of the center, tension of the belt, and parallel of
the pulley. When connecting the load such as a pulley or a belt, be cautious of the allowable
thrust load, radial load, and shock, as well as tighten the screw for a coupling or a pulley not to
be unscrewed.
When attach a coupling or a pulley to the shaft, be cautious of damage on shaft or bearings and
it is banned to disassemble or change structure of the device or the shaft for connecting with a
load.
4.3.1 Direct Load Connection with Coupling
When connecting a load such as Ball screw or Tm screw directly to the shaft of the motor, use
flexible coupling as image showing above. If the center of the load and the shaft is not aligned, it
may cause severe vibration, damage on shaft or shortened life cycle of bearings.
4.3.2 Load Connection with Pulley, Belt, and Wire
The motor shaft and the load shaft should be parallel. Connect the motor shaft and the line
which connects the center of two pulleys to a right angle.
4.3.3 Load Connection with Gear
The motor shaft and the load shaft should be parallel. Connect the motor shaft to the center fo
gear teeth side to be interlocked.