Chapter 2: Setup and Operation
Stride MQTT Gateway User Manual, 1st Edition
2-2
Getting Started
Before you begin setting up the MQTT gateway, please make sure the following conditions are met:
1. The hardware is installed as described in the Mounting and Wiring sections of Chapter 1.
2. You have the necessary connection information on hand to connect to your MQTT broker.
3. You have a device on hand with a web browser and the ability to connect to the MQTT gateway
via its RJ-45 Ethernet port, either over a LAN or directly with a crossover cable.
The device is configured through its web interface. To begin, connect to the device via an Internet browser.
The default Ethernet configuration is:
– IP address : 192.168.1.100
– Subnet Mask : 255.255.255.0
– Default Gateway: 192.168.1.1
– User Name: admin
– Password: password
