1
2
3
4
5
6
SW2
SW1
ANTENNA
SHIELD
PG3 CONNECTOR
PIN1 = OPEN COLLECTOR CH1 OUT PUT.
PIN2 = 9 TO 24 VOLT DC INPUT SUPPLY.
PIN3 = NOT USED.
PIN4 = OPEN COLLECTOR CH2 OUT PUT.
PIN5 = GROUND.
PIN6 = GROUND.
D1
FHCRX-1V2, FHCRX-2V2 and FHRX-2V2 Installation Instructions
Multi-Frequency Receivers
Doc # 160025_00
Part # 13365
Released 16/09/13
Thank you for purchasing an ATA Receiver. Familiarise yourself with the following instructions prior to commencing set up. Store this
information in a safe place for future reference. There are 2 types of Multi-Frequency Receivers;
a. The FHCRX-1 or FHCRX-2 series receivers have relays on board which provide normally open or normally closed contact for controlling
virtually any electronic device including garage doors and gate openers. The relays can be programmed to any three modes - pulse,
hold or timer. One or both relays can be programmed with any of the three modes.
NOTE:
Timer mode is select able only with the ATA Programmer. Refer to the Programmer’s manual for instructions on setting Timer
mode.
b. The FHRX-2 receiver has transistors on board which provide an open collector contact for controlling virtually any electronic garage
door or gate.
ANTENNA
AC SKT
PWR SKT NC NO COM
PG3-CONNECTOR
SW1
JP1
LED
ANTENNA
AC SKT
PWR SKT NC NO COM
PG3-CONNECTOR
SW1
JP1
LED
JP2
SW2
NC NO COM
FHCRX-1V2
FHCRX-2V2
SETTING RELAY OPERATING MODES (FHCRX-1V2 and FHCRX-2V2)
Pulse Mode - Relay contact is active whilst transmitter button is pressed.
Hold Mode - Relay changes state at each press of transmitter button. Hold, Release, Hold,
etc. (like an on/off switch).
Timer Mode - Relay will remain active for the programmed duration.the timer is adjustable
from 0 seconds to 655.34 seconds in .01second steps
RELAY-1 Pulse Mode - Remove JP1 jumper or do not bridge the two pins.
RELAY-1 Hold Mode - Bridge the two pins on JP1 jumper.
RELAY-2 Pulse Mode - Remove JP2 jumper or do not bridge the two pins.
RELAY-2 Hold Mode - Bridge the two pins on JP2 jumper.
FHRX-2V2
HOW TO CONNECT FHRX-2V2 RECEIVER WITH ATA HARNESS
TO DOOR/GATE OPENERS:
CONNECTING FHRX2V2 TO GDO-6, GDO-9, GDO-11, NEOSLIDER
V+ or 24V+
BLACK
BLUE
RED
OV
OSC
1
2
3
4
5
6
SW2
SW1
ANTENNA
SHIELD
PG3 CONNECTOR
D1
