16
ATS-3AM & ATS-2AM
Dominator Tempo & Syncro Instruction Manual
Fig.6.6.2
Fig.6.6.3
WARNING! The manufacturer is not responsible for any radio
or TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user’s
authority to operate the equipment.
IMPORTANT WARNING
LOCATE THE WALL MOUNTED REMOTE CONTROL:
(1) WITHIN SIGHT OF DOOR.
(2) AT MINIMUM HEIGHT OF 5 FEET ABOVE FLOORS,
LANDINGS, STEPS OR OTHER ADJACENT WALKING
SURFACE SO SHALL CHILDREN ARE NOT ABLE TO
REACH IT, AND
(3) AWAY FROM MOVING PARTS OF THE DOOR.
(4) PLACE THE ATTACHED ENTRAPMENT WARNING LABEL
ON WALL NEXT TO WALL MOUNTED TRANSMITTER.
USE AN ADDITIONAL MECHANICAL MEANS (PLATE,
BOARD, ETC.), WHICH CAN SECURE THE LABELS
TO SURFACES TO WHICH THE ADHESIVE WILL NOT
ADHERE.
(5) DO NOT REMOVE OR PAINT OVER THIS LABEL.
6.6 Coding Transmitters
6.6.2 Install Wireless Wall Mounted Remote Transmitter
a. Turn the wall switch over and pull the tab to commission the battery.
(Fig 6.6.2)
b. Store the transmitter code as per instructions in
Section 6.6.1
. Test the
transmitter button.
c. Mount the transmitter using parts provided in a convenient location, yet
out of reach of children and at least 5 feet off the ground.
(Fig 6.6.3)
d. Make sure the door is visible from this location.
6.6.5 Remotely Coding Remote Control Transmitters
Using this method transmitters can be coded without access to the
opener’s control panel as long as a pre-coded transmitter is available.
a. Take any pre-coded transmitter. Press the button for the function to
be duplicated and release.
b. Using a small needle / pen, press and hold firmly for two seconds
the middle button, through the Coding Hole
(Fig 6.6.4)
.
c. Within ten (10) seconds take the additional transmitter you wish to
code. Hold the new transmitter’s button for two seconds, pause for
two seconds, hold again for two seconds and then release.
d. Wait for ten (10) seconds and then press the new transmitter’s button
to test.
Fig.6.6.4
6.6.3 Erasing All Remote Control Transmitter Codes
a. Press the MODE button repetitively until the TRANSMIT
LED is lit.
b. Press and hold the MODE button for 10 secs, let the MODE button go
when the main light stops flashing.
c. Follow steps a - e in Storing the Transmitter Code to code new
transmitters.
6.6.4 Vacation Mode
a. To turn on Vacation mode and lock out all remotes, press the button on
the remote programmed with Vacation Mode.
b. To turn off Vacation Mode, press the transmitter button programmed to
vacation mode to turn off.
