Automatic Heating Modulex E8, Инструкция по эксплуатации и руководство пользователя

Страница: 49 / 70

MODULEX CONTROLLER OPERATION
47
Table 6-1. E8 Controller Failure Codes - Continued
FAILURE
CODE
FAILURE DESCRIPTION
Communication Error
E 90 E8: Address 0 and 1 on BUS. IDs BUS 0 and 1 may not bee used simultaneously
E 91 E8: BUS ID used. The set BUS ID is already in use by another device
E 99 E8: Internal failure
E 200 Communication Error HS1
E 201 Communication Error HS1
E 202 Communication Error HS1
E 203 Communication Error HS1
E 204 Communication Error HS1
E 205 Communication Error HS1
E 206 Communication Error HS1
E 207 Communication Error HS1
Internal Error
E 81
E8: EEPROM error. The invalid value has been replaced with default value (Check
parameter values)
6.2 PROCESSING & CLEARING FAILURE CODES
When a failure occurs, the appropriate failure code will be displayed along with a
“Flashing Triangle”. To
process and clear the failure, proceed as follows:
NOTE
If the cause of the failure has not been corrected, the displayed Failure
Code will reappear after performing the following steps.
1. Open the hinged cover on the Controller (see Figure 2-2).
2. Press the Program Key. The red LED will light. Also the display will show the failure code and the
number of the suspect module.
3. Correct the cause of the failure.
4. Press the Program Key again. The red LED will go off and the Failure Code will clear.
5. If more than one failure (or more than 1 failed module) exists, repeat the above steps until all failure
codes are cleared.
6. Close the hinged cover on the Controller.
7. Monitor the display to ensure no other Failure Codes appear.
8. Resume normal operation after all failures have been cleared.