Automatic Heating Modulex E8, Инструкция по эксплуатации и руководство пользователя

Страница: 3 / 70

MODULEX CONTROLLER OPERATION
1
1. INTRODUCTION
The information in this Section provides a guide to the operation of the Modulex Boiler using the E8
Controller mounted on the front of the unit. It is imperative that the initial startup of this unit be
performed by factory trained personnel. Operation by untrained personnel, prior to the initial startup,
will void the equipment warranty. In addition, the following CAUTIONS and WARNINGS must be
observed at all times:
All initial installation procedures must be completed prior to
attempting to start the unit.
THIS SYSTEM UTILIZES 240 VAC POWER. IT MUST NOT BE
SERVICED BY PERSONNEL WHO ARE NOT FACTORY
CERTIFIED SERVICE TECHNICIANS.
DO NOT ATTEMPT TO DRY-FIRE THE BOILER. STARTING
THE UNIT WITHOUT A FULL WATER LEVEL CAN
SERIOUSLY DAMAGE THE UNIT AND MAY RESULT IN
PERSONAL
INJURY OR PROERTY DAMAGE. THIS
SITUATION WILL ALSO VOID ANY EQUIPMENT WARRANTY.
2. E8 CONTROLLER DESCRIPTION
The E8 Controller is housed in a compact enclosure measuring 145 mm x 100 mm. The Controller is
mounted on the front of the Modulex Boiler and contains all of the controls, indicators and displays
necessary to adjust, operate and troubleshoot the Modulex Boiler.
The front of the Controller (Figure 2-1) contains a hinged cover which, when closed, reveals a mult-
function LCD display and a Rotary Knob. When the Controller cover is opened, it provides access to
additional controls and indicators used for installation setup, operation and troubleshooting tests for the
Modulex Boiler. These items are illustrated and described in Figure 2-2 and the Table 2-1.
Figure 2-3 illustrates and describes the type of information provided on the LCD display.
LCD
DISPLAY
COVER
Figure 2-1. E8 Controller With Cover Closed
ROTARY
KNOB