AUTOLIFT SP1400, Инструкция по эксплуатации

Страница: 15 / 45

INSTALLATION
7
WHEELCHAIR LIFT
DEVICE
SP 1400
MODEL
15
7.1 RECEIPT AND INSPECTION
On receipt of the ramp, you must perform the following inspections:
-
Check that the supplied items correspond to the order specifications and the transport docket.
-
Check that the packaging is intact and that no parts have been broken or damaged during
transportation.
-
Carefully check that the devices have not been damaged during transportation and that no parts
have been removed and/or tampered with.
-
Check that all documentation necessary for installation has been provided.
IF THE DELIVERED DEVICE DOES NOT COMPLY WITH THESE
REQUIREMENTS, NOTIFY THE MANUFACTURER IMMEDIATELY.
7.2 STORAGE AND NON-USE OF THE LIFT
If the lift is not to be used for a period, proceed as follows:
-
Store the ramp in a covered location away from the elements.
-
All electrical / electronic parts must be kept wrapped to protect against moisture.
-
The storage temperature must be b5°C and +50°C.
-
All sliding parts (guides, cylinders etc.) must be protected from dust and rust.
-
Do not store for over 6 months. For longer periods of storage, before putting into service contact the
manufacturer to have the lift conditions inspected.
7.3 TRANSPORT
The ramp must be transported using a vehicle (van, lorry etc.) of an appropriate size and capacity.
The lift is shipped by the manufacturer packed in a crate measuring 150 x 125 cm.
The total height of the crate with the lift is 50 cm.
For the weight, refer to the Technical Data chapter
STORAGE OF THE LIFT IN CONDITIONS THAT DO NOT COMPLY
WITH THE ABOVE DESCRIPTION SHALL INVALIDATE THE
WARRANTY FOR ANY PARTS TO BE REPLACED.