Auto
Monitor
User Manual Version 7.22
Page 6 of 70
Figure 3: AutoMonitor - Rear view
1 GSM antenna connector
5 Driver’s Aid connector
2 GPS antenna connector
6 Calibration port
3 SIM card slot
7 Motion sensor port
4 Rollover Sensor connector
8 Power port
2.2 Driver Aid
The driver aid unit indicates rollover state of the vehicle. When the vehicle is safe and stable,
where the rolling-over probability is little, the driver aid displays green light. When the vehicle’s
rollover state is above the safe zone but below the critical zone, an amber light is lit as warning.
When the vehicle has approached the critical zone of rolling over, a red light is lit to indicate the
vehicle is about to rollover unless slowed down and handled safely.
The driver aid unit also contains a speaker which sounds audible alarms when the vehicle’s
rollover state is not in the safe zone. The audible alarm can be switched off through the settings
menu under audio section.
The driver aid unit should be mounted on the dashboard, where drivers can see it clearly without
any distraction to the driving style.
Note: Driver aid unit will flash all three LED lights if there is a communication problem
between the dashboard unit and the rollover sensor.
Figure 4: Driver’s aid module
GP
S
GS
M
SIM
AutoTest AutoMonitor
SERIAL
NO
Sensor
Driver’s Aid
00000
1
2
3
4
5
6
7
8
A
B
D