Auto
Monitor
User Manual Version 7.22
Page 38 of 70
3.5.4 On-Board Diagnostic (OBD II)
The on-Board diagnostic codes stored in the Engine Control Unit (ECU) are retrieved by
AutoMonitor system via CAN bus that gets shared with the ECU of the vehicle. The diagnostic
trouble codes (DTCs) are recorded codes of the problems experienced the vehicle.
3.5.5 Engine parameters (optional)
Depending on the user requirements, the device can be revised to read additional parameter
information via the CAN bus interface.
3.5.6 Emission related parameters (optional)
Depending on the user requirements, the device can be revised to read emissions related
parameters via the CAN Bus.
4. CONFIGURATION
The device configurations cannot be adjusted while the vehicle is moving. To access settings
menu, make sure the vehicle is stationary.
4.1 Display
LCD display brightness and contrast values can be adjusted via the configuration menu. To adjust
display related settings, perform the following operations:
Press Menu button (
) and scroll to the Setting menu and then press OK, use
and
keys to
scroll through the menu. When Display menu appears, press OK. Device will prompt the user to
set contrast value. Brightness menu can be accessed by pressing OK key from the contrast
menu. To return back to main screen press return key (
).
4.2 Audio
Audio settings allow user to turn On or Off rollover alarm sound during a rollover event. The audio
settings can be accessed via Settings menu then Audio menu. If the rollover warning of the
AutoMonitor is set to MUTE, the LED lights in the driver’s aid could be used to detect rollover
warnings.
4.3 Date Time
The date and time menu allows users to configure time-zone. If OK key is pressed during the time-
zone screen, device will display current date and time that is adjusted by the currently set time-
zone.
4.4 Daylight saving
Daylight saving time can be set using Settings->Daylight menu. If the daylight saving is active
during summer, set DST to ON and press OK.