EXP-52
7
This feature is optional at time of installation.
I.
TRIGGER TEST
After arming the EXP-52 in either the PASSIVE or MANUAL mode, test
the system in the following manner.
1. Open any door or other protected opening. The siren will sound
instantly, and the lights will flash.
2. If the pre-warning feature is activated, the EXP-52’s SIS-5 impact
sensor will respond to a light shock with a chirp sound, and trigger
the alarm when a heavier shock is detected. (Please refer to A-4 for
details).
3. If optional sensors have been installed, arm the EXP -52 and test
according to the directions of the particular sensor installed.
If triggered in the armed condition, the EXP-52 will sound its siren and
flash the lights for 60 seconds; then it will stop and automatically reset
and rearm. If the violation continues, the alarm will sound and lights will
flash for two 60 second cycles.
J.
PROGRAMMING THE REMOTE TRANSMITTERS
NOTE
:
Each time the programming mode is entered, all programmed
transmitter codes will be automatically deleted and must be re-
programmed
. This is an important security feature. If any transmitter is
lost or stolen, enter the programming mode and re-program existing
transmitters. Transmitters can only be programmed by entering the
programming mode. Existing codes will remain in memory even if
power to the EXP-52 is disconnected.
To program the EXP-52 transmitters, follow the directions as written
below,
in their exact order!
