Auto Crane HC-5 NEXSTAR, Руководство пользователя, Страница: 25 / 88

25
NexStar Operation
HC-7X NEXSTAR
Auto Stow
Auto Stow allows the operator to move the boom to the home position (usually the cradle) without having
to manually move the boom. From the starting position, the boom will elevate to a preset angle, swing
over to the home position, and lower down into the final position, a predefined angle above the home
position. Once in this position, the operator can fine-tune the boom position in the cradle if needed.
The boom preset angle and speeds are all preset in the controller. Once initiated,
the operator only must hold the trigger to enable boom motion.
Prior to using Auto Stow, the following initial conditions must be met:
1. The boom is fully retracted
2. The hoist block is properly stowed on load hook
3. The boom is lowered to an elevation below the home position
Retracting the boom and stowing the hoist block must be done by the operator
prior to initiating Auto Stow. There is no means of detecting these conditions
prior to initiating boom motion. If Auto Stow is used without retracting the boom
and stowing the hoist block, equipment damage and/or personal injury could
result.
Auto Stow will not initiate if the boom is above the home elevation.
To initiate Auto Stow, first fully depress and hold the trigger, then press the Engine Start/Stop switch down
to Engine Stop and then release the trigger. Auto Stow will be the default menu selection.
NOTICE
!
WARNING
NOTICE