21
Tread
check, the
Single Tire
check only provides one measurement for each
tire.
All Tread Check
The
All Tread
check examines your tire wear in three separate areas (outer,
center, and inner) for a more comprehensive analysis.
To perform a Tire Tread Check
1.
Tap the
Tire Tread
application icon on the Main Job Menu.
2.
Select a check mode when prompted.
3.
Place the tool on the tire surface and tap the Power/Measure
button to start measuring.
4.
The measurement will display on the screen.
5.
Select a wheel location on the screen, swipe left to view details
and scroll down on the screen to view additional information
including tread wear analysis and maintenance suggestions.
NOTE
For optimal measurements, ensure the tool is placed firmly on the tread and
that the laser line is perpendicular to the groove being measured.
4.2 Details
The
Details
screen shows a wide variety of tire wear information. After
measurements are shown on the screen, select a wheel location, swipe left
to view details of the chosen tire. Below are the main sections featured in
the
Details
section:
1) Graphic measurements
— shows the measurement data graphically
with various colors indicating different degrees of tire wear.
The graphic measurements of the
All Tread
check mode
displays the wear measurements of three areas of the tire: inner,
center, and outer. The
Single
check displays only one
measurement for each tire.
2) Braking distance
— displays the stopping distance for the test vehicle
based on both the tire tread depth and tire type selected. This section
is followed by wear analysis and maintenance suggestions.
