83
4) Follow the on-screen instructions to pull the parking brake button. Wait
for appropriately three seconds until the parking brake is set. When the
operation is successfully completed, a “Completed successfully”
message will display on the screen, press
OK
to exit.
Parking Brake: Workshop Mode
This service is used to activate and deactivate the installation position for the
Automatic Hold brake. In this mode the parking brake is moved into the
opened position and temporarily deactivated (personal protection).
The installation position must be activated for the following repairs:
Replacement of brake pads.
Replacement of a brake caliper.
Replacement of an actuator.
Select
Parking Brake: Workshop Mode
and follow the on-screen
instructions to perform a series of operations to initiate the brake pad after
replacement.
When the operation is successfully completed, a “Completed successfully”
message will appear on the screen. Press
OK
to exit.
Battery Management System (BMS) Service
The Battery Management System (BMS) allows the scan tool to evaluate the
battery charge state, monitor the close-circuit current, register the battery
Figure 6-8
Sample EMF Star-up Screen 3
