59
To set a trigger:
1.
Tap the drop-down button on the right side of a parameter to open a submenu.
2.
Tap the
Trigger
button on the right side of the submenu to open the Trigger Settings
window.
3.
Tap the
MIN
button on the right side, and enter the required minimum value.
4.
Tap the
MAX
button on the right side, and enter the required maximum value.
5.
Tap
OK
to save the settings and return to the Live Data screen, or tap
Cancel
to exit
without saving.
When the trigger is set, a trigger mark will display in front of the parameter. The mark is gray
when it is not triggered, and orange when triggered. Moreover, two horizontal lines display on
each of the data graphs (when Waveform Graph Mode is applied) to indicate the alarm point.
The threshold lines are shown in different colors to differentiate them from the parameter
waveforms.
9.10 Active Test
The
Active Test
function is used to access vehicle-specific subsystem and component tests.
Available tests vary by vehicle.
During an active test, the tablet sends commands to the ECU to activate the actuators. This
test determines the integrity of the system or part by reading ECU data, or by monitoring the
operation of the actuators. Such tests may include toggling between two positions of a
solenoid, relay or switch.
Selecting
Active Test
displays a menu of available test options. Available tests vary by vehicle.
Select a test from the menu options. Follow the instructions displayed on the screen to
complete the test. Procedures and instructions vary by vehicle.
