Power Output
120 Watts RMS
Maximum Load
40 Ohms @ 70 Volts
Power Bandwidth
60Hz - 17kHz (- 3dB)
Frequency Response
60Hz - 23kHz (- 3dB)
Total Harmonic Distortion
0.5% @ 1kHz rated power
Signal To Noise Ratio
-80dB
Input Sensitivity
700mV
Outputs
70V, 4 Ohm, 8 Ohm
Controls
One gain control on rear of the unit via flathead screwdriver control
Indicators
Power “on” LED
Power Source
120VAC 60Hz 3 pin IEC connector; 24VDC
Power Consumption
300 Watts
Protection
Current Limiter protection, plus AC and DC fuses
Dimensions/Weight
3.5" H x 19" W x 11" D (Chassis Dimensions only). 26.5lb
Rack Mounting
Standard
ARCHITECTURAL AND ENGINEERING SPECIFICATIONS
The 120 watt power amplifier shall be designed to run 70 volt line audio systems. The unit shall also feature
a 4 and 8 ohm output. The amplifier may be desk or rack mounted.
The amplifier must be capable of delivering 120 watts into an 40 ohm inductive load with less than 0.5% dis-
tortion measured at 1kHz and with system hum and noise of -80dB or better. Internal current limiting shall
protect the amplifier from both overload and overdrive conditions.
The amplifier shall be an Australian Monitor Installation Series model AMIS120P.
UL APPROVED
PO Box 3126, Lynnwood, WA 98046
• Voice:
425-673-5175
• Fax:
425-673-7825
• Website:
www.australianmonitor.com
• Email:
AUSTRALIAN MONITOR AUDIO INC.