Illustrated fitting instructions
PLEASE TURN PAGE FOR INSTALLATION STEPS 8, 9 & 10
Note: If NOT using the ‘Caretaker’ feature - go to Step 6.
5.
6.
4.
2.
3.
1.
‘Caretaker’ feature
‘Caretaker’ feature
‘Caretaker’ feature
Lockbody Installation
Cylinder installation
Preparation
ILLUSTRATED FITTING INSTRUCTIONS
ELEGANCE
for hinged security doors
E TH
L
C
IS
Y
P
C
A
E
C
R
K
E
A
S
G
A
IN
E
G
L
P
Select the
exterior handle assembly
which includes the
caretaker mechanism shown below.
When viewing the door from the outside of the house,
if the hinges are on the right hand side, rotate the ‘D’ pin towards the
right hand marks - RH. As shown below.
If the door hinges are on the left hand side, rotate the ‘D’ pin
towards the left hand marks - LH. As shown below.
‘D’ pin shown
rotated for
Right Hand
door
Caretaker
mechanism
‘D’ pin shown
rotated for
Left Hand
door
Slide the Caretaker spindle
vertically under the
caretaker cover
plate as shown
below.
Go to step 7
caretaker
spindle
caretaker
spindle fitted
cover plate
If
not
using the ‘caretaker’ feature, push the plastic plug which
has the Austral logo, into the square hole shown below.
Move the ‘D’ pin until the Austral logo on the plastic plug is vertical.
After adjusting, give the plug a final push to insure it is tight.
‘D’ pin
plastic plug with
Austral logo
square hole
(PK0234) ELEGANCE instructions (Trade A4) R5.cdr
7.
Fit the correct Snib Lever
Select the
interior handle assembly
with
snib lever hole.
Select the correct snib lever as shown in the box below.
Hold the
snib lever
horizontally and insert it into
the
snib lever hole,
turn it until vertical to secure it.
If the
handle
does not point towards the door
hinges, remove it from the
handle plate
and
exchange with the other
handle.
While holding the
snib lever
vertical,
place the lever assembly against the door.
snib lever
towards door
hinges
interior handle
assembly
hollow snib, to u
with caretaker
se
snib with spindle, to use
without caretaker
or
Austral
Lock
is to assist in easy installation.
- Do not
remove.
The
sticker
on the rear of the
lockbody
ensure that the
rear slide
is pushed
completely down before assembling the
lockbody
into the
door cutout
.
If the
sticker
has been broken or removed,
lockbody
sticker
rear slide
Depress the
auxiliary bolt
to ensure the
main bolt
is fully extended.
Insert the
key
and turn to locked position.
Assemble the
cylinder
through the lock
so the
cylinder
protrudes equally from
both sides.
NOTE : the cylinder
cam
must rotate as
shown below. (cam turns towards front
of door)
Turn
key
to unlocked position and
remove
key.
Insert
#10 x 38mm cylinder screw
& tighten.
NOTE : test,
main bolt
should not depress
main bolt
cylinder
screw
auxillary bolt
cam operation
cylinder
cylinder cam
accessory kit, be sure to follow the cylinder installation
procedure within the multipoint kit instructions.
IMPORTANT : If installing ELEGANCE with a multipoint
156mm
16mm
Door Cutout
Insert the
lock body
into the
door
cutout
Secure the
lockbody
with the two
#8x13mm lockbody screws.
lock body
lock body
screw
door cutout
