AUSSIE TONNEAU ATB01234, Инструкция по монтажу

Страница: 1 / 4

Tonneau Cover Fitting Instructions
2012 DMAX Dual Cab With Out Head Board
Part Number: ATB01234
BASIC TOOLS REQUIRED
Drill, 4mm Drill Bit, Tape Measure, Rivet Gun, Marking Pencil / Pen, Clear Silicone / Silicone Gun
CONTENTS
1 x Tonneau Cover 2 x Bar Brackets
16 x Rope Buttons 3 x Aluminium Rope Track - 510mm
1 x Tonneau Support Bar 28 x Rivets
4 x Dowel
INSTALLATION PROCEDURE
NOTE - Read entire instructions prior to start.
- Pictures are for illustration purposes only.
STEP 1: FIT ROPE TRACK
Using a 4mm drill bit, drill a hole 50 mm in from each
end and 9 mm up from the bottom of the 3 pieces of
rope track as shown in
Figure 1 . Join the 3 pieces of
rope track together using the 2 pieces of wooden dowel
as shown in
Figure 2
Place the remaining 2 pieces of dowel in
the ends of the rope track. Ensure the flat
side of the rope track is the surface
positioned vertical against the tub face.
Drill though the holes in the rope track into
the front wall of the tub.
Apply a bead of clear silicone along the
centre of the front edge of the rope track.
Figure 1
Figure 2