TX3750-1C/2C/4C-SAW 434
Owner’s Manual
RF SAW Transmitter with
UM3750
Encoder
RF transmitter with SAW resonator, up to 4 channels. It is ideal for applications where codified controls, high
efficiency and low extraneous emissions are required.
Available Models
TX3750-1C-SAW 434
: 1 p/button transmitter
TX3750-2C-SAW 434
: 2 p/buttons transmitter
TX3750-4C-SAW 434
: 4 p/buttons transmitter
How to use
By pressing and releasing any of the provided push buttons (according to model) the code will be
transmitted on the related channel.
Channel 1
p/button
Channel 3
p/button
Channel 4
p/button
Data
transmission
LED
Channel 2
p/button
Full kit
TX3750-4C-SAW 434 Model
Battery replacement
When the transmission LED light intensity is reduced, the supplying battery needs to be replaced. To this
purpose loose the screw in the back side of the radiocontrol, and then carefully open the plastic shell. Once
the old battery is removed, fit the new one (
V23A, 12 V model
) paying very much attention not to invert
the polarity. Close back the transmitter’s plastic shell paying attention not to damage the integrated circuit.
Please do not waste the old battery in the environment but place it inside the containers provided at this
purpose, for its proper and correct disposal.
Positive pole [+]
Negative pole [-]
AUREL shall not be deemed liable if product and related information are changed without notice. The Buyer shall be the sole responsible of the device use.
AUR°EL S.p.A.
Via Foro dei Tigli, 4 - 47015 Modigliana (FC) – ITALY Rev. B, July 17th 2003
Tel.: +390546941124 – Fax: +390546941660 Pag 1 of 2
http://www.aurel.it
- e-mail:
