AURATON S03 RTH, Руководство пользователя

Страница: 9 / 24

8
The diode is illuminated green - the operating device is
off (the COM and NC contacts are closed).
The diode is illuminated red - the operating device is on
(the COM and NO contacts are closed).
The diode is blinking green - the receiver is waiting for the
device to be paired - (chapter “Paring of a wireless
controller with the receiver”).
The diode is blinking red - the repeater is waiting for a
device to unpair - (chapter: “Unpairing the controller
from the receiver”).
The diode is blinking red and green alternately:
ALARM - the receiver’s connection with one of the paired
devices is broken - (chapter: “Special
situations”).
RESET - the receiver unpairs all the previously paired
devices - (chapter: “Unpairing all devices paired
with the receiver”).
Key - description of diode signaling in the receiver
In order to mount the controller on a wall:
1. Take off the enclosure of the controller.
2. Drill two 6 mm diameter holes in the wall.
3. Put two wall plugs in the drilled holes.
4. Fasten the back part of the enclosure to the wall
using the screws provided with the set.
5. Put on the controller’s enclosure.
If the wall is made of wood, there is no need to use wall plugs. Only 2.7 mm
diameter holes (instead of 6 mm) should be drilled and the screws should be
driven directly into the wood.
9
Installation/replacement of batteries
The battery compartment can be found inside the controller, on the
front part of the enclosure. In order to install the batteries, take off
the enclosure.
battery compartment
- 2 x AAA 1,5 V batt .
Put two 1.5 V AAA batteries inside the battery
compartment, paying attention to the polarity of
the batteries.
Mounting the controller on a wall
a hole for
the fastening screw
NO
COM
NC