AURATON 200 RTH, Инструкция по эксплуатации

Страница: 9 / 24

8 9
To fix the AURATON 200 controller to the wall:
1. R e m o v e t h e e n c l o s u r e ( a s d e s c r i b e d o n t h e " B a t t e r y
installation/replacement" section).
2. Drill 2 holes diameter 6 mm in the wall (use the back of the controller
enclosure to set the right spacing of the holes) .
Fixing the AURATON 200 RTH controller to the wall
3. Place plastic plugs in the drilled holes.
4. Screw the back of the controller enclosure to the wall with the two screws
provided.
5. Install the batteries and replace the controller enclosure.
NOTE : No expansion bolts are needed for wooden walls. Just drill holes diameter 2.7 mm
(instead of 6 mm) and screw the screws directly into the wood.
Alternative fixing methods
The controller can be mounted to a smooth surface with
e.g. two-sided adhesive tape.
The controller can also be placed in any location on an even surface on
a support at the back of the enclosure.
hole for a
mounting screw
hole for a
mounting screw
3 . Connect the heating device to the
control connection terminals of the
AURATON RTH receiver.
Proceed in accordance with the service
manual of the heating device. Most
commonly, the
COM (common) and NO
(normally open) terminals.
4 . Connect power supply conductors to the
power supply terminals of the AURATON
RTH receiver, observing safety rules.
5 . After connecting the conductors, they must
be secured with the cable tie clamps and
reinstall protective covers of the
AURATON
RTH receiver.
Fastening the RTH receiver
1 . Take off protective covers from the lower
and upper part of the AURATON RTH
receiver.
2 . Take off cable tie clamps from the lower
and upper part of the AURATON RTH
receiver.
protective cover
cable tie clamp
NOTE: When installing the AURATON RTH
receiver its power supply must be
disconnected. It is recommended that the
installation is performed by a qualified
specialist.
NOTE:
The permanent electrical system
of a building must include a breaker
and an overcurrent protection.
~ 230V AC