auna Oakland DAB, Инструкция по эксплуатации

Страница: 50 / 56

50
EN
flashing on the display until the deletion is complete.
NOTE: Pressing the delete DEL button will completely delete all files/tracks
on the USB device or SD card.
Removing the USB device / SD card
• First move the function selector to another mode (tuner, phono, tape),
then turn the volume knob counterclockwise to turn off the power.
• To remove a USB device, pull it out of the USB port.
• To remove a memory card, press the memory card inwards and then
release it. The card will be released (partially ejected) and you can
remove it by hand.
THE AUXILIARY INPUT
Listening to a CD (or other auxiliary input)
1. Turn the volume knob clockwise to turn the equipment on.
2. Use the function selector to select TAPE/AUX mode, then connect the
external audio device (such as a CD player) to the AUX IN socket at the
front of the equipment. The audio signal from the external audio device
will now be played through the system.
3. If an external audio device is connected to the AUX IN socket, playing of
the auxiliary device takes priority over cassette playback.
NOTE: If you won't use the unit for a long time ,you had better take the CD
out from the disk tray door .
AUX IN encoding
1. Use the function selector to select TAPE/AUX mode and then insert a
memory device (USB drive, SD or MMC card).
2. Press the record REC button, it will take 3 - 4 seconds to read the
memory device, then the USB or SD icon will be flashing on the LC
display.
3. Press the skip up or skip down button to select the desired mode
(USB or SD) for encoding, then press the record REC button again to
confirm. (You can skip this step if only a USB drive or an SD/MMC card is
inserted.)
4. The system will start the encoding mode after a few seconds. During
encoding, the USB or SD icon will be flashing on the display.
5. To finish encoding, press the stop button. The display will show “END”
and return to TAPE/AUX mode.